Frequently Asked Questions

Culvert cost depends on pipe diameter, trench depth, and how much driveway surface needs to be restored after installation. Sizing is determined on site from actual ditch and driveway measurements — a pipe that's undersized for the ditch it drains into will back up water rather than move it. Free estimates are available.

Confirm the crew sizes the pipe from the ditch width and road height rather than using a standard size for every job. Residential lots near Kingsland commonly have open roadside ditches, and a mismatched pipe backs water up under the driveway instead of carrying it through. Also verify the contractor is licensed and insured before work starts.

D&L Development LLC clears fallen trees from driveways and yards in St. Marys and nearby communities. The crew cuts sections working from the roadside inward so each piece is manageable, then loads and hauls everything off in the same visit using their own excavator and dump truck.

Storm debris pricing depends on the number of trees down, how close they are to structures, and how much material needs to leave the property. A single tree across a driveway is straightforward; a large tree near a house takes more planning to section safely. Free estimates are offered — the quote reflects what's actually on the ground.

Look for a crew that brings their own hauling equipment so debris actually leaves the property rather than getting piled at the edge of the lot. Licensed and insured coverage matters most when a tree is near a structure or a fence. Owner-operated crews are often easier to coordinate with directly after a storm when scheduling is tight.

The crew serves Folkston, Kingsland, Woodbine, St. Marys, Waycross, Brunswick, Hoboken, Darien, and Savannah. Work is primarily residential, with some smaller commercial jobs. Customers in Charlton and Brantley County are a regular part of the schedule.

The person who walks the lot and quotes the work is the same person running the excavator — there's no hand-off between an estimator and a subcontractor. On cut-and-fill sites, the owner runs a laser to establish how much dirt moves before any work starts, which keeps the final scope close to what was quoted.

Lot size, density of brush and trees, number of stumps, how much material needs to leave the site, and whether grading follows the clearing all drive cost. On overgrown parcels, forestry mulching can reduce expense by grinding brush in place rather than hauling it out — but large trees and stumps still require excavator work regardless of method.

Owned equipment means the schedule isn't dependent on a rental yard's availability or a subcontractor's calendar. For jobs like drainage and culvert work where conditions found mid-dig can change what's needed, the crew can adapt on site without waiting for a different machine to show up.

Expect a free on-site estimate where the crew walks the property before quoting — conditions on the ground determine the scope. After the job, cleared material is hauled off by the company's own dump truck, so debris doesn't stay on the lot. A walkthrough confirms the finished work matches what was agreed.

The crew walks the lot to identify where water collects and which direction it needs to run before recommending a fix. Standing water near the house often needs surface regrading; a driveway that crosses a ditch almost always needs a correctly sized culvert. Both issues can show up on the same parcel and get handled in one visit.